The changes from 1.23 to 1.24 are very minor.Īnd if it aint broke. Notice the use of the expression "will most likely also work".įlashed two drives in secondary mode and had no problems though. "This procedure will most likely also work if you have a Windows 7 or Vista 32-bit (NOT 64-bit) Install or Recovery CD/DVD and a USB stick." Though to quote again from the above link: Not tried to flash with a 32 bit Windows disk before. ![]() No drives will be discovered if administrator privileges are not enabled." So on launch, run with Admin. IMPORTANT: The Update Tool requires administrator privileges. Vertex Firmware Setup Guide (New) Apr 8, 2009. Quite extensive changelog this time around. If you want to see what firmware youre currently running on, go to Device Manager and follow to here: Changelog is here: Release Notes. Firmware 1.32 for OCZ Sandforce drives, ( Vertex 2, Vertex LE, Agility 2) is available. Its for Vertex SSDs only and does not support any other SSDs. OCZ Sandforce Drive Firmware Update 1.32/1.33 released. "On launch, the Update Tool will scan for drives. OCZ will release their TRIM utility that is functional on Vista 32 and 64bit very soon. "I will give the same warning as the 1.23 firmware (if you are not already on it): I highly recommend installing this update as a secondary drive, installing this update from Windows running on the target drive will result in er attic behaviour." If you've not had a look at this thread on the OCZ forum, then I would suggest it's a good place to start.Įven with SSDupdate, the recommended way to flash, is with your drive as a secondary.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |